Volume 272
Main Index

Pages 1-258 (20 January 1996)

Editorial Board Page iii

Preface Page ix Alan T. Riga, Gerald H. Patterson

Thermal analysis and coal assessment: an overview with new developments Pages 1-9 S.St.J. Warne

The thermal decomposition of coprecipitates and physical mixtures of magnesium-iron oxalates Pages 11-26 R.Glenn Rupard, Patrick K. Gallagher

Alternating thermal analysis techniques Pages 27-39 Rudolf Riesen, Georg Widmann, Rolf Truttmann

Reconciliation of Arrhenius and iso-conversional analysis kinetics parameters of non-isothermal data Pages 41-48 John P. Elder

AC calorimetric aspect of dynamic differential scanning calorimetry Pages 49-52 Ichiro Hatta

DSC enthalpy of vaporization measurements of high temperature two-phase working fluids Pages 53-63 Dwight D. Back, Lawrence R. Grzyll, Mary Corrigan

Characterization of microporous carbons by using TGA curves measured under controlled conditions Pages 65-73 M. Jaroniec, R.K. Gilpin, J. Ramler, J. Choma

Sinusoidal temperature treatments in thermal analysis Pages 75-85 Dun Chen, David Dollimore

Heat-flux calorimetric method for the determination of spontaneous oxidative heat rate of active carbon containing oxidizable/volatile organics Pages 87-94 Gene G. Wu, David J. Leggett

Reutilizing and retesting of parallel plate sensors in dielectric thermal analysis Pages 95-103 John Q. Whitley, Robert P. Kusy

Influence of proton ionophore and negative sites on the dielectric behavior of plasticized poly(vinyl chloride)s Pages 105-123 John Q. Whitley, Robert P. Kusy

Simultaneous dynamic mechanical analysis and dielectric analysis of polymers Pages 125-129 David D. Shepard, Benjamin Twombly

Decomposition of vinylidene chloride copolymers in the presence of selected transition metal halides Pages 131-137 B.A. Howell, J.R. Keeley

Thermal degradation characteristics of vinylidene chloride/2-[3,4-(1,1-dioxycyclopentyl)phenyl]ethyl acrylate copolymers Pages 139-146 B.A. Howell, B.B.S. Sastry, S.I. Ahmed, P.B. Smith

The property-performance differences between two blended polypropylene fibers Pages 147-155 Jonathon A. Foreman, Ken A. Klinger, Michael Wolkowicz

Mechanical reinformcement and thermal transition behaviors in nylon 6-b-polyimide-b-nylon 6 triblock copolymers Pages 157-169 F.W. Harris, B.P. Livengood, H. Ding, F.-L. Lin, S.Z.D. Cheng

Dynamic mechanical analysis (DMA) and low temperature impact properties of metallocene polyethylenes Pages 171-179 L. Woo, Michael T.K. Ling, Stanley P. Westphal

Polyethylene structural heterogeneity by thermal and rheological techniques Pages 181-189 Stanley P. Westphal, T.K. Ling, L. Woo

A TGA technique for determining graphite fiber content in epoxy composites Pages 191-199 R.Y. Yee, T.S. Stephens

Determination of enthalpy relaxation times using traditional differential scanning calorimetry for glycerol and for propylene glycol Pages 201-209 Patrick M. Mehl

New test methods to determine the causes of failures in ABS drain waste and vent plumbing systems Pages 211-220 James W. Mason

Applications of thermal analysis to development of gas generant formulations used to inflate automobile airbags Pages 221-231 I.V. Mendenhall, S.F. Reid

Versatility of the application of thermal analysis to the simulation of gas desulphurisation Pages 233-241 K. Wieczorek-Ciurowa

DSC analysis for the evaluation of an energy storing wallboard Pages 243-251 D. Feldman, D. Banu

Author index Page 253

Subject index Pages 255-258